TM 5-3810-306-20
3.
REMOVE FUEL FILTER ASSEMBLY.
a. Remove two nuts (8), lockwashers (9) and
flatwashers (10) securing fuel filter housing to
frame. Discard lockwashers (9).
b. Remove fuel filter (1) from studs.
c. Remove elbow (7) and valves (11) from fuel filter
assembly.
d. Remove adapter (12) from valve (11).
4.
INSPECT PARTS FOR DAMAGE. REPLACE IF
DAMAGED.
INSTALLATION:
1.
INSTALL FUEL FILTER (1).
a. Install valves (11), adapter (12) and elbow (7) on
fuel filter.
b. Put fuel filter (1) on studs.
c. Install two flatwashers (10), new lockwashers (9)
and nuts (8) to secure fuel filter.
2.
CONNECT TWO FUEL LINES TO FUEL FILTER.
a. Connect "OUT" fuel line (6) and new packing (5)
to elbow fitting.
b. Connect "IN" fuel line (4) and new packing (5) to
IN port.
c. Ensure fuel filter bowl (3) is secure and open
valves (11).
3.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
4.
START ENGINE. (REFER TO TM 5-3810-306-10.)
5.
MAKE SURE SEDIMENT BOWL FILLS WITH
FUEL. ENSURE THERE IS NO LEAKAGE.
END OF TASK
5-14
