TM 5-3810-306-20c. Remove center bearing (16) from yoke assembly(15).d. Remove four capscrews (12) and lockwashers(13) from yoke spline flange to free cross andbearings (10). Discard lockwashers (13).CLEANING:WARNINGDry cleaning solvent P-D-680 is toxicand flammable. Wear protectivegoggles and gloves and use only in awell ventilated area. Avoid contactwith skin, eyes, and clothes and don’tbreathe vapors. Do not use nearopen flame or excessive heat. Flashpoint is 100°F-138°F (38°-59°C). If youbecome dizzy while using cleaningsolvent get fresh air immediately andget medical aid. If contact with eyesis made, wash your eyes with waterand get medical aid immediately.WARNINGCompressed air used for cleaningpurposes will not exceed 30 PSI. Useonly with effective chip guarding andpersonal protective equipment(goggles/ shield, gloves, etc.).1.CLEAN ALL METAL PARTS WITH P-D-680. DRYWITH COMPRESSED AIR.2.INSPECT ALL PARTS FOR DAMAGE. REPLACEPARTS AS REQUIRED. CROSS AND BEARINGSMUST BE REPLACED AS A SET.REASSEMBLY:1.LUBRICATE YOKE SPLINES ON PROPELLERSHAFTS. (REFER TO LO 5-3810-30612).2.REASSEMBLE PROPELLER SHAFT(S).a. Install seal (9) on yoke assembly (8).b. Align marks and insert yoke spline (2) into yokeassembly (8).c. Install cross and bearings (1 and 5) on yokespline (2) and yoke assembly (8) using four10-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
