TM 5-3810-306-20
PROPELLER SHAFT REPAIR
TOOLS:
General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
Cleaning solvent P-D-680 (Item 80, Appendix C)
Clean rags (Item 1, Appendix C)
Grease (MIL-G-10924) (Item 9, Appendix C)
Lockwashers (Item 15, Appendix C) (8 Required)
Lockwashers (Item 16, Appendix C) (8 Required)
EQUIPMENT CONDITIONS: Propeller shafts removed. (Refer to page 10-2.)
DISASSEMBLY:
1.
DISASSEMBLE PROPELLER SHAFT(S).
NOTE
Propeller shaft from torque converter
to transmission shown in Figure A.
Use steps a through c to repair rear
axle
to
transmission
and
center
bearing
yoke
assembly
to
transmission propeller shaft.
a. Scribe a mark across yoke spline (2) to yoke
assembly (8).
b. Disassemble propeller shafts by removing four
capscrews (3 and 7) and lockwashers (4 and 6)
to remove cross and bearings (1 and 5) from
yoke spline (2) and yoke assembly (8). Discard
lockwashers (4 and 6).
c. Separate yoke spline (2) from yoke assembly (8)
and remove seal (9).
2.
DISASSEMBLE PROPELLER SHAFT BETWEEN
TRANSMISSION YOKE AND CENTER BEARING
YOKE.
NOTE
Propeller shaft from front axle yoke
assembly to transmission propeller
shaft yoke assembly shown in Figure
B.
FIGURE A
a. Scribe a mark across yoke spline (11) and
center bearing yoke assembly (15).
b. Disassemble yoke assembly (15 from spline (11)
by removing nut (14).
10-4
