TM 5-3810-306-20
INSTALLATION:
1.
LUBRICATE SPLINES ON PROPELLER SHAFTS.
(REFER TO LO 5-3810-30612.)
2.
INSTALL PROPELLER SHAFT(S).
a. Position and align marked flanges at front
propeller shaft and front axle yoke. Secure with
four capscrews (10) and new lockwashers (11).
b. Align center bearing (7) with holes in frame and
secure center bearing (7) with two capscrews
(5), washers (6), nuts (8) and jam nuts (9).
c. Align marked flanges on center bearing yoke
and transmission yoke with flanges on propeller
shaft and secure with four capscrews (1 and 4)
and new lockwashers (2 and 3) on each end of
propeller shaft.
d. Torque
transmission
to
torque
converter
propeller shaft mounting bolts to 45 ft-lbs (60
Nm).
e. Torque mounting bolts on transmission to axle
propeller shafts to 90-110 ft-lbs (120-147 Nm).
3.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
4.
TEST FOR PROPER OPERATION. (REFER TO
TM 5-3810-306-10.)
END OF TASK
10-3
