AIR DRYER DESICCANT CARTRIDGE REPLACEMENT - cont

AIR DRYER DESICCANT CARTRIDGE REPLACEMENT

AIR DRYER DESICCANT CARTRIDGE REPLACEMENT - cont - TM-5-3810-306-20_332

TM-5-3810-306-20 Container Crane 40-Ton Rough Terrain Model RTB75CC Manual
Page Navigation
274

TM 5-3810-306-20 d. Remove ball check valve retaining clip (12) and remove and discard rubber ball valve (13). e. Remove and retain spring (14), spring seat (15), bolt (16), and cartridge shell (17). Discard oil separator filter (18), two perforated plates (19) and desiccant material (20). WARNING Dry cleaning solvent P-D680 is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or excessive heat. The flash point is 100°-138°F (38°-59°C). If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is made, wash your eyes with water and get medical aid immediately. Compressed air used for cleaning purposes will not exceed 30 PSI. Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.). 3. CLEAN DESICCANT PLATE (8) THOROUGHLY USING SOLVENT, ENSURING PURGE ORIFICE AND CHECK VALVE SEAT ARE CLEAN. INSTALLATION: 1. ASSEMBLE DESICCANT PLATE ASSEMBLY (6) AND DESICCANT CARTRIDGE ASSEMBLY (9). a. Insert one of perforated plates (19) into shell (17), felt cloth up, and tap it firmly to bottom. (Felt always faces desiccant material). b. Slide oil separator filter (18) over cartridge bolt (16) with gasket surface next to shell (17). c. Install bolt (16) with oil separator (18) into bottom of shell and through center hole of perforated plate (19) in bottom of shell (17). d. Pour entire package of desiccant material into shell (17), ensuring none is lost. Handle it carefully so bolt does not fall out. NOTE If the shoulder of the bolt does not extend above the perforated plate, tap the side of the desiccant container. e. Level desiccant material and install second perforated plate (19), felt cloth down. Ensure shoulder of bolt (16) is centered and extends slightly above top of perforated plate. f. Set conical spring (14) on top of perforated plate. (Large diameter down small diameter up). g. Place spring seat (15) on top of spring (14). 11-16

Privacy Statement
Press Release
Contact