TM 5-3810-306-20
THROTTLE CYLINDER AND CONTROL ROD REPLACEMENT
TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
Lockwashers (Item 2, Appendix C) (2 Required)
EQUIPMENT CONDITIONS: Wheels are chocked.
Disconnect ground cable at shunt. (Refer to page 8-109.)
Air system is purged. (Refer to page 11-2.)
REMOVAL:
1.
DISCONNECT AIR LINE (1), FITTING (2), AND
REMOVE CONTROL ROD (3).
a.
Tag and remove air line (1) on throttle cylinder
(7). Remove fitting (2). Set aside for installation.
b.
Inspect fitting (2) for damage, replace as
required.
c.
Remove capscrew (17), lockwasher (16) and flat
washer (15) securing control rod ball joint at fuel
injection pump lever.
NOTE
Note
which
hole
control
rod
is
mounted for reassembly.
d.
Remove capscrew (13) and locknut (12)
securing control rod (3) at throttle cylinder.
Remove rod.
2.
REMOVE THROTTLE CYLINDER (7).
a.
Hold throttle cylinder (7) in place.
b.
Remove two capscrews (8), flatwashers (9),
lockwashers (10), and nuts (11). Discard
lockwashers (10).
c.
Lower throttle cylinder (7) from bracket.
11-35
