TIRE INFLATION ASSEMBLY

THROTTLE CYLINDER AND CONTROL ROD REPLACEMENT - cont

TM-5-3810-306-20 Container Crane 40-Ton Rough Terrain Model RTB75CC Manual
Page Navigation
293

TM 5-3810-306-20 TIRE INFLATION ASSEMBLY TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033) SUPPLIES: None EQUIPMENT CONDITIONS: Wheels are chocked. Disconnect ground cable at shunt. (Refer to page 8-109.) Air system is purged. (Refer to page 11-2.) REMOVAL: NOTE Tire inflation outlet fittings are located on both left and right sides of crane. Procedures are same with only fitting (12) being different. Use this procedure for both. 1. REMOVE TIRE INFLATION ASSEMBLY. a. Remove nipple (1) and body (2). b. Tag and remove air line (3) from elbow. c. Remove pipe nipple (7) from coupling anchor (4). d. Remove coupling anchor (4), locknut (6) and washer (5). Remove coupling anchor (4) from mounting plate. e. Remove other fittings (8, 9, 11 and 12) and check valve (10) as required. INSTALLATION: 1. INSTALL TIRE INFLATION ASSEMBLY. a. Install coupling anchor (4) through mounting bracket hole and secure with washer (5) and locknut (6). b. Install body (2) and nipple (1) into anchor, tighten to secure. c. Install pipe nipple (7) into coupling anchor (4). d. Install check valve (10) and fittings (8, 9, 11 and 12) onto coupling anchor (4). e. Install air line (3) to elbow (12). 11-37

Privacy Statement
Press Release
Contact