TM 5-3810-306-20
b.
Remove two solenoid coils (3) by removing
retaining nuts (6) and sliding coils up from valve
(4).
INSTALLATION
NOTE
Prior to installation, coat all preformed
packings with clean hydraulic oil and
fitting threads with Loctite 545.
1.
INSTALL SOLENOID COILS.
a.
Slide solenoid coils (3) over shaft on valve (4)
and secure with nuts (6).
2.
INSTALL REAR AXLE LOCKOUT VALVE.
a.
Install fittings and new preformed packings on
lockout valve.
b.
Position rear axle lockout valve on frame studs.
c.
Place grounding wire (7) on frame stud and
secure wire and lockout valve (4) with new
lockwashers (2) and nuts (1).
d.
Remove tags and install hydraulic lines to
lockout valve.
e.
Remove tags and connect electrical connectors
(5).
2.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
3.
INSTALL REAR DECK. (REFER TO PAGE 15-16.)
4.
TEST FOR PROPER OPERATION AND INSPECT
FOR LEAKS. (REFER TO TM 53810-306-10.)
END OF TASK
16-11
