TM 5-3810-306-20
REAR AXLE LOCKOUT VALVE
TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
Lockwashers (Item 2, Appendix C) (2 Required)
Preformed packing (Item 3, Appendix C) (6 Required)
Preformed packing (Item 62, Appendix C) (2 Required)
Loctite 545 (Item 13, Appendix C)
Hydraulic oil (Item 6, Appendix C)
EQUIPMENT CONDITIONS: Disconnect around cable at shunt. (Refer to page 8-109.)
Rear deck removed. (Refer to page 15-16.)
REMOVAL:
1.
REMOVE REAR AXLE LOCKOUT VALVE (4).
a.
Tag and disconnect five hydraulic lines to
lockout valve.
b.
Tag and disconnect electrical connectors (5).
Remove two nuts (1) and lockwashers (2) from
frame studs. Discard lockwashers (2).
c.
Remove grounding wire (7) from frame stud.
d.
Remove rear axle lockout valve.
e.
Remove fittings and preformed packings from
lockout
valve
(4)
and
retain
fittings
for
reassembly. Discard preformed packings.
NOTE
The solenoid coils (3) mounted on
lockout valve may be removed without
removing hoses. Use the following
procedure:
2.
REMOVE SOLENOID COILS (3).
a.
Loosen valve mounting hardware enough for
removal of solenoid coils.
16-10
