TM 5-3810-306-20
2.
INSTALL SWING BRAKE VALVE.
a.
Position swing brake valve (1) to mounting plate,
align holes and secure with capscrews (7), new
lockwashers (8) and nuts (9).
b.
Remove tags and install hydraulic hoses to
swing brake valve (1).
NOTE
It may be necessary to adjust clevis (6).
See adjustment procedure.
c.
Align clevis (6) with brake pedal (4) and secure
with clevis pin (3) and hitch pin (2).
3.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
4.
INSTALL CAB FRONT PANEL. (REFER TO PAGE
15-10.)
ADJUSTMENT:
1.
ADJUST SWING BRAKE VALVE.
WARNING
Engage swing lock prior to starting
engine.
a.
Start engine and set throttle to idle. (Refer to TM
5-3810-30610.)
b.
Use slight pressure to depress valve shaft
toward brake valve until it stops.
c.
Remove hitch pin (2) and clevis pin (3).
d.
Pull up on brake pedal into non-braking position.
e.
Loosen clevis locknut (10) and adjust clevis (6)
until hole in clevis aligns with hole in brake
pedal. Tighten locknut (10).
f.
Insert clevis pin (3) and secure with hitch pin (2).
END OF TASK
16-9
