TM 5-3810-307-10
Table 6-1. Operator Troubleshooting (continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 3.
Alternator pulley loose on shaft.
a.
Inspect alternator pulley. If OK, do step 4.
b.
Contact Organizational Maintenance to tighten alternator pulley.
Step 4.
Charging system malfunction.
a.
Contact Organizational Maintenance.
26. CRANE WILL NOT MOVE OR MOVES ERRATICALLY (TRANSMISSION FAILURE).
Step 1.
Low transmission oil level.
a.
Remove dipstick and check transmission oil level. If OK, do step 2.
Refer to PMCS in Section 5.
b.
Fill to proper level.
Step 2.
Transmission shift lever at N-Neutral.
a.
Check position of transmission shift lever.
Step 3.
Defective transmission.
a.
Contact Organizational Maintenance.
27. TRANSMISSION OIL TEMPERATURE ABOVE NORMAL.
Step 1.
Low transmission oil level.
a.
Remove dipstick and check oil level. Refer to PMCS in Section 5. If
OK, do step 2.
b.
Fill to proper level.
Step 2.
Transmission not down shifting properly.
a.
Manually shift to lower gear.
