TM 5-3810-307-10
Table 6-1. Operator Troubleshooting (continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 2.
Cylinder rods or outrigger beams dirty.
a.
Clean cylinder rods or outrigger beams.
Step 3.
Outrigger system malfunction.
a.
Contact Organizational Maintenance.
31. OUTRIGGER SYSTEM WILL NOT ACTIVATE.
Step 1.
Hydraulic oil low.
a.
Check hydraulic oil level. Refer to PMCS in Section 5. If OK, do
step 2.
b.
Service hydraulic reservoir.
Step 2.
Outrigger system malfunction.
a.
Contact Organizational Maintenance.
32. OUTRIGGER SYSTEM ACTIVATES, BUT SELECTED OUTRIGGER WILL NOT RETRACT
OR EXTEND AND LOWER AS DESIRED.
Step 1.
Outrigger system malfunction.
a.
Contact Organizational Maintenance.
33. BOOM RAISES OR LOWERS ERRATICALLY.
Step 1.
Hydraulic oil low.
a.
Check hydraulic oil level. Refer to PMCS in Section 5. If OK, do
step 2.
b.
Service hydraulic reservoir.
Step 2.
Low engine rpm.
a.
Increase engine rpm.
