TM 5-3810-307-24-1-1
LED#
INPUT NAME
TRANSMISSION SHIFT CONTROL POSITION
F1
F2
F3
F4
F5
F6
N
R3
R2
R1
01
Forward
X
X
X
X
X
X
20
Reverse
X
X
X
02
1st Range
X
X
X
21
2nd Range
X
X
X
X
X
X
22
Splitter
X
X
X
2.
Throttle Inputs (08,23) and Adjustments.
d.
Gradually increase engine speed.
a.
Make sure transmission is in neutral (N)
(1)
LED #23 should turn off at 890-
and main hydraulic pump is disengaged.
940 engine rpm.
b.
Start engine and run at idle. The "E:xxx"
(2)
If necessary, adjust carriage bolt
display should be approximately 840-
(30, Figure 2-2-3) closer to idle
860.
switch to increase rpm setting
(1)
If reading is zero or erratic, check
and farther away from switch to
speed sensor, harnesses, and
decrease setting.
APC 100 fuse and relay box.
e.
Increase engine speed farther.
(2)
If reading is greater than the
range, check and adjust throttle
(1)
LED #08 should turn off at 2250-
cable and linkage as necessary,
2350 engine rpm.
refer to Section 2 - THROTTLE
AIR
CYLINDER
AND
(2)
If necessary, loosen mounting
THROTTLE LINKAGE.
hardware slightly for adjusting bar
(39, Figure 2-2-3) and adjust
(3)
If still out of range, adjust fuel
capscrew (36) clockwise to
injection pump idle setscrew.
decrease setting and counter-
Setscrew is located between
clockwise to increase setting.
pump control lever and pump
body.
Turn screw counter-
NOTE
clockwise to increase and
clockwise to decrease.
A slight reduction in the setting speed
usually occurs as the mounting hardware
c.
Check LEDs.
is tightened. Therefore adjust toward the
upper end of range.
(1)
LED #23 (idle switch) and LED
#08 (throttle position switch)
f.
Increase engine speed to full throttle.
should
be
illuminated
yellow/orange.
(1)
"E:xxx" display should be 2500-
2781.
(2)
If
not
illuminated,
check
harnesses and APC 100 fuse
(2)
If out of range, check and adjust
and relay box for faulty
throttle cable and linkage as
connections/components. Check
necessary, refer to Section 2 -
appropriate throttle switch for
THROTTLE AIR CYLINDER
proper adjustment, refer to
AND THROTTLE LINKAGE.
Section 2, THROTTLE AIR
CYLINDER AND THROTTLE
LINKAGE.
2-3-20
