SM02-025-0
Page 47
N OTE
The idler gear and taper bearing cup as-
sembly and the forward high clutch as-
sembly must be installed in the converter
housing at the same time as the idler gear
must be positioned between the forward
clutch front bearing and the clutch drum.
Install the idler outer taper bearing with
small diameter of taper down. Make sure
locating ring is in full position in ring
groove.
29. Spread the ears on the forward high clutch
front bearing locating ring.
Spread the ears on the reverse clutch front
32.
bearing locating ring. Tap the reverse and 3rd and 4th
clutch assembly into the converter housing. Align the
snap ring groove in the bearing with the snap ring in
the housing, being certain the bearing snap ring is in
full position in the snap ring groove.
30.
Position the outer spacer on the shaft.
33.
Install the forward clutch shaft rear bearing into
the bearing bore with the bearing snap ring toward
the front of the housing.
31. Install the retainer nut on the shaft and torque
200 to 250 pounds-foot (27.1 to 33.8 kgm). Stake the
nut securely into the shaft notch.
