SM02-025-0
Page 48
34. Align the forward clutch shaft piston ring
sleeve with the groove in the housing. Tap the sleeve
36.
Install the output shaft front taper bearing cup.
into position and secure with the sleeve retainer ring.
Coat the outer diameter of the oil seal with
37.
Permatex #2 and press the seal in the bearing cap
35. Position the forward clutch assembly into the
transmission housing. Use caution as not to damage
with the lip of the seal in. Remove any excess sealant.
the forward shaft piston rings. Tap the clutch into
Install a new O-ring on the bearing cap. Install the
front bearing cap and shims.
position.
Install the bearing capscrews and washers and
38.
tighten to the torque specified in the Torque Chart.
