SM02-025-0
Page 45
retainer ring located in the reaction member support.
Tap the turbine shaft and bearing into position being
certain the bearing snap ring is in full position in the
snap ring groove.
21. Position the charging pump drive gear, bearing,
and support in the housing.
19. Position the auxiliary pump drive gear, bearing
and support in the housing.
Install the support screws and torque 23 to 25
22.
pounds-foot (3.1 to 3.3 kgm).
20. Align the holes in the bearing support with the
holes in the housing. Install the support screws and
lockwashers. Torque the screws 23 to 25 pounds-
foot (3.1 to 3.3 kgm).
23. Position the pump drive idler gear and bearing
on the idler gear stub shaft.