SM02-025-0
Page 42
Assembly.
NOTE
Assembly of the stator support to con-
verter housing must be completed within
a 15 minute period from start of screw
installation. The special screw is to be
used for one installation only. If the
screw is removed for any reason is must
be replaced. The Loctite left in the holes
must be removed with the proper tap and
cleaned with solvent. Dry hole thorough-
ly and use a new screw for reinstallation.
4.
Install the 6 special stator support screws.
Torque the screws 12 to 16 pounds-foot (1.6 to 2.1
kgm).
NOTE
The bearing part number must be up.
1.
Install a new sealing ring expander spring and
oil sealing ring on the support. The expander spring
gap is to be 180 degrees from the sealing ring hook
joint. Press the support bearing into position.
2.
Clean the stator support mounting surface and
tapped holes with solvent. Dry thoroughly ensuring
the tapped holes are clean and dry.
5.
With a new O-ring on the shaft, position the
reverse idler shaft and lock ball in the converter
housing.
3.
Position the support into the converter housing,
aligning the holes in the support with the holes in the
housing. Tap the support into position.
6.
With a new O-ring on the shaft, position the
