SM02-025-0
Page 52 Change-1
53.
Repeat procedure in step 52 for the idler shaft.
With the rear taper bearing cup in the rear bear-
56.
ing cap, apply a very light coat of Permatex #2 to the
outer diameter of the rear output oil seal. Press the
seal in the bearing cap with the lip or the seal in. With
a new O-ring in position, install the bearing cap.
Install the idler shaft rear bearing retainer nut.
54.
Torque the nut 200 to 250 pounds-foot (27.1 to 33.8
kgm).
57.
Install the bolts and lockwashers and tighten to
the torque specified in the Torque Chart on page 14.
55. Position the speedometer gear on the output
shaft if so equipped.