SM02-025-0
Page 59
87.
Install the impeller cover to impeller screws and
90. See special section on page 61 for drive plate
lockwashers. Torque to the value specified in the
installation. Install the drive plate. Refer to Drive
Torque Chart.
Plate Installation.
88.
Position a new O-ring over the impeller cover
91. To install the control valve assembly it is re
commended two aligning studs be used. Position -
bearing.
a
new control valve to housing gasket on the housing.
Install the control valve assembly.
89. Position the impeller cover bearing cap on the
bearing.
