SM02-025-0
Page 56
oil baffle. Position the oil baffle in the housing and
install the retaining ring. Be sure the ring is in full
position in the ring groove.
75. The use of two aligning studs will facilitate
aligning the converter housing to the transmission
housing. Install the converter housing assembly to
NOTE
the transmission assembly using extreme caution as
to align the clutch pilots into the clutch disc hubs. As
Use extreme caution as not to cut, break
or unhook the oil sealing ring on the
the clutch pilots enter the disc hubs turn the turbine
support.
shaft and output shaft back and forth. This will help
align all of the clutch inner discs with the disc hubs.
DO NOT FORCE THIS OPERATION. When all the
Install the impeller and hub assembly using
77.
clutches are properly aligned, the converter housing
caution as not to damage the o il baffle oil seal.
will be tight against the transmission housing. Install
two housing to housing capscrews and Iockwashers.
Remove the aligning studs. Install the remaining
capscrews and lockwashers. Torque the capscrews
to the torque specified in the Torque Chart.
78. Position impeller hub bearing spacer on stator
support.
NOTE
If equipped with a fixed reaction member,
Apply a light coat of Permatex #2 to the outer
76.
diameter of the oil baffle oil seal. Press the seal in the
follow steps 79 and 80. If equipped with
a freewheeling reaction member, follow
baffle with the lip of the seal toward the impeller hub
steps 81 thru 83.
bearing. Position a new oil baffle sealing ring on the
