SM03-026-0
Page 22
3. Remove the planetary pinions including the thrust
1. Press the lock pins into the planetary pins completely
rings and the needle bearings.
(dowel pin installed through the planetary pin towards the
inside).
Assembly.
CAUTION
NOTE
Because of a 0.003 IN. (0.10 MM) difference
Depending upon the construction of the
in diameter, the planetary pin must not be
axles, caged or free needle bearings are
driven towards the outside to avoid damaging
used. For free needle bearings, paper shells
the bore.
are used for assembly.
1. Install the bearing (1) in the planetary gear (2). Upon
insertion, the outer paper shell is removed.
2.
Drive the planetary pin towards the inside.
thrust ring (3) are installed into the planetary carrier (5)
(the planetary carrier must be in the horizontal position).