SM03-026-0
Page 23
CAUTION
STEERING KNUCKLE BEARING AND DOUBLE
UNIVERSAL JOINT SHAFT BEARING.
Always install the planetary pin (4) from the
Removal.
inside toward the outside due to the difference
in the diameter. Take care to line up the key
1. Securely place the axle housing in a horizontal
holes in the planetary pins and the carrier.
position.
NOTE
2.
Remove the screws securing the differential assembly
to the axle housing.
When installing the planetary pin, the inner
paper shell is removed .
NOTE
NOTE
The differential lock should always be
switched to the ON position when installing
When installing the planetary pin, the outer
or removing the universal joint or axle shaft.
bore of the planetary carrier (5) is to be
If necessary, loosen the control cylinder from
coated with a sealant.
the control lever and hold the lock down by
hand or fasten it down in place.
NOTE
It is necessary to switch on the differential
lock to prevent the sliding sleeve from
dropping out of the shift fork and into the
axle housing when pulling out or sliding in
the uaniversal joint or axle shaft. This would
mean disaassembly of the axle.
3. Install the planetary pin (4).
NOTE
Planetary carriers incorporating a slot for an
O-ring are to have an O-ring installed.
4. After installation of the planetary pin (4), install the
lock pin (6).
3.
Remove the axle shaft f rom the differential.