TM 5-3810-307-24-2-2
Valve Covers - Removal (0-27)
15 mm
Remove the special capscrews, o-ring seals, valve
covers and gaskets.
Injector Nozzles - Removal (0-28)
Rust Penetrating Solvent
CAUTION
When rust has formed on the hold down nut,
the injector can turn in the bore when the nut
is loosened. This will cause severe damage
to the head by the injector locating ball
cutting a groove in the bore.
Soak the hold down nut with a rust penetrating solvent
for a minimum of 3 minutes.
Brass Drift Pin, Hammer
CAUTION
Excessive force will damage the injector.
Tap the injector body with the hammer and drift pin to
loosen any rust.
24 mm Box Wrench, Adjustable Wrench
Hold the injector body with an adjustable wrench while
you loosen the hold down nut with a 24mm box
wrench.