TM 5-3810-307-24-2-2
Injector Puller 3823276
Remove the injectors. If the injector is extremely difficult
to remove, remove the injector o-ring and fill the bore
around the injector with a penetrating solvent. Attach
the injector puller and pull the injector out as far as
possible, then use the injector puller slide hammer to
tap against the puller nut and drive the injector into the
bore. Repeating this procedure will allow the solvent to
penetrate to the injector tip and loosen the carbon
deposits on the tip.
Refer to Component Section 6 for the injector test
procedures.
Rocker Levers - Removal (0-29)
14 mm, Screwdriver
Loosen the nuts on the rocker lever adjusting screws
and loosen screws until they stop.
13 mm, 18 mm
Remove the pedestal/head bolts from the rocker shaft
pedestals and lift off the pedestal and rocker lever
assemblies.
NOTE
Refer to Component Section 3 for
disassembly of the rocker lever assemblies.
Push Rods - Removal (0-30)
Remove the push rods.
NOTE
Refer to Component Section 4 for the push
rod inspection procedure.