TM 5-3810-307-24-2-2
Position the alternator on the bracket and secure it with
the mounting capscrew and spacer.
Do not tighten at this time.
CAUTION
Do not tighten at this time. To avoid
misalignment and overstressing the lower
support mounting ear on the alternator, leave
the capscrews loose until all the alternator parts
are installed.
Install the alternator link.
Check the alternator pulley visually or with a straight
edge to make sure it is aligned with the other pulleys
and is parallel to the front face of the block.
After all parts are assembled, tighten all capscrews in
the following sequence:
1.
Alternator-to-alternator bracket capscrew.
2.
Lower brace-to-alternator capscrew.
3.
Alternator-to-water inlet capscrew.
4.
Water inlet-to-block capscrews.
NOTE
Wrench size and torque value is determined
by the make and model of alternator. Refer to
the Engine Component Torque Values.
0-88 C-1