M5 CARTRIDGE-ACTUATED RELEASE ASSEMBLY

INITIATOR CABLE ASSEMBLY - cont

M5 CARTRIDGE-ACTUATED RELEASE ASSEMBLY - cont - TM-10-1670-298-20P_81

TM-10-1670-298-20P Container Delivery System A-7A Cargo Sling Manual
Page Navigation
70

TM 10-1670-298-20&P 2.27 M5 CARTRIDGE-ACTUATED RELEASE ASSEMBLY. This task covers: a. Inspect b. Replace INITIAL SETUP Tools References Paragraph 2.9 Materials/Parts M5 Cartridge-actuated release assembly (Appendix C) Cotter Pin (Appendix C) Equipment Condition Cable release assemblies removed INSPECT EXPLOSIVE HAZARD · DO NOT attempt to disassemble the M5 cartridge-actuated release assembly, which has been sealed at the manufacturing source. Serious Injury or death could result. · Because of special handling and stowage procedures required with cartridge- actuated devices, the release assembly IS NOT to be installed until immediately prior to mating the container with the aircraft. The safety pin is to be removed only during the preflight check. Conduct a technical/rigger-type inspection in accordance with the instructions contained in paragraph 2 9. REPLACE a. Remove red warning flag from safety pin (Figure 2-32). 2-62

Privacy Statement
Press Release
Contact