TM 10-1670-298-20&P
MAINTENANCE OF WEB ASSEMBLIES (CTU-2/A)
2.28
CONE WEB ASSEMBLY.
This task covers:
a.
Inspect b.
Repair c.
Replace
INITIAL SETUP
Tools
References
Paragraph 2.8
Paragraph 2.9
Materials/Parts
Cone Web Assembly (Appendix C)
Equipment Condition
Parachute compartment assembly removed.
M5 cartridge-actuated release assembly removed.
Tall cone assembly removed.
INSPECT
Conduct a technical/rigger-type inspection in accordance with the Instructions contained In paragraph 2.9.
REPAIR
a. Restitching. Restitch the cone web assembly according to original construction, instructions contained in
paragraph 2.8, and the specifics shown In Table 2-3.
b. Splicing. Splicing shall be accomplished using the instructions in paragraph 2.8
REPLACE
a. Remove. (Figure 2-33)
(1)
Place parachute compartment assembly on floor.
(2)
Disconnect the parachute cable assembly lockpin from the cone on the web cone assembly.
2-65
