1
Fitting, lubrication
13
Clutch bearing carrier
2
Coupling
14
Lockwire
3
Lubrication tube
15
Screw, cap, 3/8-16 x 1 in. (2 rqr)
4
Elbow
16
Short clutch shaft
5
Fitting, lubrication
17
Long clutch shaft
6
Screw, cap, 5se-18 x 1/2 in. (2 rqr)
18
Woodruff key, No. 607
7
Washer, lock, 5/16 in. (2 rqr)
19
Woodruff key, No. 607
8
Inspection plate
20
Yoke
9
Stud, 5/8 x 2 in. (6 rqr)
21
Screw, cap, 3/8-16 x 11/4 in. (6 rqr)
10
Nipple
22
Washer, lock, 3/8 in. (6 rqr)
11
Spring (2 rqr)
23
Bearing cover
12
Clutch bearing
24
Clutch housing
Figure 69. Carrier engine clutch housing, exploded view.
(3) Remove the flywheel and flywheel housing
should not exceed 0.002 indicator reading.
as instructed on figure 72.
b. Disassembly. Disassemble the flywheel and
269.
Carrier Engine Flywheel and Flywheel
flywheel housing in numerical sequence as illustrated on
Housing Reassembly and Installation
a. Reassembly. Reassemble the flywheel and
268.
Carrier Engine Flywheel and Flywheel
flywheel housing in the reverse of the numerical
Housing Cleaning, Inspection, and Repair
sequence as illustrated on figure 73.
b. Installation.
a. Cleaning. Clean all parts with an approved
(1) Install the flywheel and flywheel housing
cleaning solvent and dry thoroughly.
as illustrated on figure 72.
b. Inspection and Repair. Inspect all parts for
(2) Install the clutch assembly (par. 265).
(3) Install the starter assembly (TM 53810-
excessive wear and damage. Replace or repair all
207-20).
defective parts. Maximum run-out of 124 the flywheel
TAGO 5030A
124
