TM 5-3810-294-34
b.
Installation.
(1) Refer to figure 2-6 and install rear
drumshaft assembly.
(2) Refer to figure 2-2 and install gantry.
(3) Refer to figure 2-1 and install sheet
metal removed during disassembly.
(4)
Refer to TM 5-3810-294-20 and
perform the following operations:
(a) Install rear drum brake band.
(b) Install rear drumshaft drive chain
case.
(c) Open hydraulic reservoir shut-off
valve.
(d) Bleed hydraulic system to remove
any air trapped in the hydraulic lines.
Note. Be sure no hydraulic fluid comes. into
contact with any brake or clutch band while performing
any maintenance operation.
2-16.
Front Drumshaft Assembly
a. Removal.
(1)
Refer to TM 5-3810-294-20 and
perform the following operations:
(a) Close hydraulic reservoir shut-off
valve.
(b) Remove front drum brake band.
(2) Refer to figure 2-1 and remove sheet
metal, as required, to allow removal of front drumshaft
from the cab.
(3) Refer to figure 2-7 and remove front
drum shaft assembly.
6.
DRIVE OUT MASTER CAIHN LINK PINS.
REMOVE CHAIN.
7.
REMOVE SHAFT NUT, LOCKWASHER,
AND WASHER.
8.
SLIDE SPROCKET OFF.
9.
REMOVE BEARING RETAINER CAP-
SCREWS AND LOCK WSHERS (SAME
AS OPPOSITE END OF SHAFT).
10.
REMOVE BEARING CAP NUTS AND
REMOVE BEARING
CAP.
11.
ATTACH SIUTABLE LIFTING DEVICE.
REMOVE DRUMSHAFT ASSEMBLY
ME 3810-288-35/2-6 2
Figure 2-6. Rear drumshaft assembly, removal and
installation (Sheet 2 of 2).
2-24
