TM 5-3810-294-34
4.
DISCONNECT HYDRAULIC HOSE AT SWIVEL. PLUG HOSE AND SHAFT HOLE.
5.
REMOVE SWIVEL.
6.
REMOVE NUT, LOCKWSHER, AND WASHER.
7.
REMOVE CLUTCH AS A UNIT.
8.
SUPPORT ASSEMBLY USING A SUITABLE LIFTING DEVICE. REMOVE NUTS AND
LOCKWASHERS. REMOVE REVERSING SHAFT.
ME 3810-288-35/2-8 2
Figure 2-8. Reversing shaft assembly, removal and installation (sheet 2 of 2).
b.
Installation.
in this machine. Each shaft drives the upper in one
(1) Refer to figure 2-8 and install reversing
direction only. The left shaft drives the upper to the right.
The right shaft drives the upper to the left. Be sure the
shaft.
(2) Refer to TM 5-3810-294-20 and perform
correct shaft is removed in the event of swing system
the following operations:
malfunction.
b. Removal.
(a) Install reversing shaft chain and
adjust chain tension.
(1) Refer to TM
5-3810-294-20 and
(b) Open hydraulic reservoir shut-off
perform the following operations:
valve.
(a) Close hydraulic reservoir shut-off
(c)
Bleed hydraulic line to the
valve.
(b) Loosen horizontal swing shaft
reversing shaft.
2-18. Horizontal Swing Shafts
drive chain tension.
a. General. Two horizontal swing shafts are
(c) Remove cover plate which allows
used
access
2-27
