TM 5-3810-294-34
2-17.
Reversing Shaft Assembly
b.
Installation.
a. Removal
(1) Refer to figure 2-7 and install front
(1) Refer to TM 5-3810-294-20 and
drumshaft assembly.
perform the following operations:
(2) Refer to TM
5-3810-294-20 and
(a ) Close hydraulic reservoir shut-
perform the following operations:
off valve
(a) Install front drum brake band.
(b) Remove reversing shaft chain
(b) Open hydraulic reservoir shut-off
tension by means of the reversing shaft chain tension
valve.
adjusting idler. Lift chain from sprocket (fig. 2-8).
(c) Bleed hydraulic line to the front
(c ) Refer to figure 2-8 and remove
drum assembly.
the reversing shaft assembly.
Note. Be sure no hydraulic fluid comes into
contact with any brake or clutch band while performing
any maintenance operation.
1.
BREAK LOCKWIRE AND REMOVE END PLATE BY REMOVING ATTACHING CAPSREWS.
2.
REMOVE SPROCKET.
3.
REMOVE GEAR BY REMOVING ATTACHING COUPLING BOLTS.
ME 3810-288-35/2-8 1
Figure 2-8. Reversing shaft assembly, removal and installation (Sheet 1 of 2).
2-26
