TM 5-3810-295-34
Remove snap ring (17), plug (18) and selector valve
(7)
Using a suitable press, depress stop (47) and
(19). Remove plug (20) and special washer (21).
remove pin (46). Gently tap the opposite end of the
(5)
Remove snap ring (22) and gently tap the op-
cover and remove stop (47), packing (48), spring (49)
posite end of the cover to remove assembly. Remove
and spool spring (50). From the opposite end of the
adapter (23), spacer (24), piston guide (25), packing
cover, remove stop (51), packing (52) and spool (53).
(26), piston (27) and valve (28). At the opposite end of
(8)
Depress stop (54) and remove remaining pin
the cover, remove cap washer (29), spring cap (30),
(46). Remove stop (54),1 packing (55), spring (56), spacer
packing (31) and spring (32). Remove pipe plug (33).
(57), ball (58) and seat (59). Remove plug (60) and pipe
(6)
Remove plug (34), plug (35) and special
plug (61) from cover (62).
washer (36). Using a suitable press to compress stop (39),
z. The transmission internal tubing is shown in
remove roll pin stop (37). Then remove stop (39) and
figure 15-6. These tubes should not be removed unless
packing (38), spring (40), and pin (41). At the opposite
damaged. They should, however, be cleaned and
end of the cover, remove guide (42), packing (43), piston
checked when the transmission is disassembled.
(44) and spool (45).
15-9
