TM 5-3810-305-23
0027
REMOVAL - Continued
1
2
M0211105
Figure 2.
Cylinder Head Removal.
END OF TASK
CLEANING
1.
Clean parts IAW General Maintenance Instructions (WP 0162).
2.
Clean carbon from injector nozzle seat with a nylon or brass brush.
3.
Wash cylinder head in hot soapy water solution and dry with compressed air.
4.
Polish gasket surfaces with 400-grit paper. Use an orbital sander or sanding block to maintain a flat surface.
5.
Dry parts with compressed air.
END OF TASK
INSPECTION
1. Inspect parts IAW General Maintenance Instructions (WP 0162).
2. Inspect all parts for wear, pitting, cracks, or corrosion, and replace if necessary.
3. Inspect cylinder head surface for nicks and erosion.
4. Using a feeler gage and straight edge, check cylinder head for distortion.
Limit
Variation: 0.0039 inch (0.099 mm) within 2.00 inch (50.8 mm) diameter area. 0.003 inch (0.08 mm) overall
end-to-end or side-to-side.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00032)
