TM 5-3810-305-23
0034
REMOVAL
1.
Remove spring hose clamp (Figure 1, Item 4) and hose (Figure 1, Item 5) from tappet
cover (Figure 1, Item 3).
2.
Remove capscrews (Figure 1, Item 6), four grommets (Figure 1, Item 1), tappet cover (Figure 1, Item 3), and
tappet cover gasket (Figure 1, Item 2) from block. Remove all gasket material from mounting surfaces.
END OF TASK
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
WARNING
ADHESIVES AND SEALANTS
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause
lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety goggles and
use product in a well-ventilated area away from open flame. If ingested, keep individual calm
and seek medical attention. DO NOT induce vomiting. If contact with skin or eyes is made,
flush thoroughly with water. Dispose of cleanup rags IAW local policy and ordinances.
Failure to follow this warning may cause injury to personnel.
NOTE
Tappet cover gasket has an adhesive back. Pull off protective cover on gasket to expose
adhesive surface.
1.
Install new tappet cover gasket (Figure 1, Item 2) with adhesive side down on tappet cover (Figure 1, Item 3).
Apply sealing compound to top of gasket and block.
2.
Install tappet cover (Figure 1, Item 3), four grommets (Figure 1, Item 1), and capscrews (Figure 1, Item 6) on
block. Tighten capscrews to 18 ft-lb (24 Nm).
3.
Install hose (Figure 1, Item 5) and spring hose clamp (Figure 1, Item 4) on tappet cover (Figure 1, Item 3).
0034-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00039)
