TM 5-3810-305-23
0097
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
NOTE
If bearings, trunnions, main housing, or pivot spindle have not been replaced, use shim pack
thickness recorded during removal in this work package, and go to Step 2.
1.
Perform the following steps to determine required lower shimming:
NOTE
Lower shims to ensure alignment of pivot, axle housing sphere, and axle shaft.
a.
Read pivot dimension X (distance from lower machined surface to center of pivot) on lower face of pivot
and spindle assembly.
b.
Measure height of trunnion hearing assembly and call it Y.
c.
Read axle housing measurement Z (distance from bearing cup seat to center line of axle housing) as
stamped in bottom of lower trunnion cavity.
d.
To calculate thickness of required lower shim, substitute dimensions in the following equation:
e.
Lower shim = X - (Y+ Z).
0097-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00107)