TM 5-3810-305-23
0097
REMOVAL - Continued
8.
Remove and tag trunnions (Figure 2, Item 1) from spindle assembly (Figure 2, Item 5).
9.
Remove upper and lower bearings (Figure 2, Item 4) from trunnions (Figure 2, Item 1), if necessary.
10.
Pull pivot and spindle assembly (Figure 2, Item 5) horizontally outward from spindle assembly.
11.
If necessary, pull out bearing cups (Figure 2, Item 3).
NOTE
Pivot and spindle assembly consists of a thrust ring on splined end, a shaft bushing on other
end, and pivot and spindle.
12.
If necessary, remove thrust ring (Figure 2, Item 6) and shaft bushing (Figure 2, Item 8) from pivot and
spindle assembly (Figure 2, Item 5).
13.
Remove and discard trunnion seals (Figure 2, Item 2) from spindle assembly (Figure 2, Item 5).
14.
Remove mid-shaft (Figure 2, Item 7) from spindle assembly (Figure 2, Item 5).
1
2
3
5
4
8
5
6
4
7
4
3
2
1
M0304105
Figure 2.
Pivot and Spindle Assembly Removal.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00107)
