TM 5-3810-305-23
0097
INSTALLATION - Continued
WARNING
Weight of housing assembly is approximately 631 lb (286 kg). Use adequate lifting equipment
to lift and support housing assembly. DO NOT lift over personnel or let personnel walk
underneath suspended load. Failure to follow this warning may cause injury or death to
personnel.
NOTE
Place axle housing with input yoke in an upward direction. This will ease installation of
trunnion/bearing assemblies.
2.
Install mid-shaft (Figure 4, Item 2) in pivot and spindle assembly (Figure 4, Item 1).
1
2
M0306105
Figure 4. Pivot and Spindle Assembly Installation.
3.
If removed, install thrust ring (Figure 5, Item 6) in splined end and shaft bushing (Figure 5, Item 7) on
spindle assembly (Figure 5, Item 5).
4.
Grease center bore of pivot and spindle assembly (Figure 5, Item 5).
NOTE
If bearing cups were removed, install them at this time using a bearing installing tool.
Apply grease to trunnion bore in axle housing.
5.
Pack trunnion bearings (Figure 5, Item 4) with grease.
6.
Install new trunnion seals (Figure 5, Item 2) and bearing cups (Figure 5, Item 3) onto trunnions
(Figure 5, Item 1).
03/15/2011Rel(1.8)root(maintwp)wpno(M00107)
