TM 5-3810-305-23
0102
ASSEMBLY
NOTE
Lightly lubricate all moving parts except friction plates.
Stamped on the back of each pad holder is a code number. The first or first and second
numbers specify the friction material type. The new friction pad material must be the same
as the pads being replaced.
1.
Position two pad holder assemblies (Figure 7, Item 8) on cam side casting (Figure 7, Item 5) and carrier
casting (Figure 7, Item 6).
2.
Install two springs (Figure 7, Item 4) and spring (Figure 7, Item 7) holding pad holder assemblies
(Figure 7, Item 8) in place.
3.
Position cam side casting (Figure 7, Item 5) and carrier casting (Figure 7, Item 6) together. Install washer
(Figure 7, Item 9) and bolt (Figure 7, Item 15). Tighten bolt to 32 ft-lb (43 Nm).
4.
Install bracket (Figure 7, Item 3) with two washers (Figure 7, Item 2) and bolts (Figure 7, Item 1).
Tighten bolts to 32 ft-lb (43 Nm).
5.
Install two push pins (Figure 7, Item 10) in cam side casting (Figure 7, Item 5).
6.
Install operating cam (Figure 7, Item 11) on stud in cam side casting (Figure 7, Item 5).
7.
Install washer (Figure 7, Item 14) and castle nut (Figure 7, Item 12) on stud in cam side casting
(Figure 7, Item 5). Do not install cotter pin (Figure 7, Item 13) at this time. See Installation, Step 14
in this work package.
8.
All sliding parts must move freely.
7
6
5
3
4
2
1
8
4
15
14
10
9
13
11
12
M0533105
Figure 7. Parking Brake Assembly.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00113)
