TM 5-3810-305-23
0144
REMOVAL
WARNING
Never disconnect hydraulic lines or fittings before venting pressure. Turn dipstick cap 1/4 turn
to safety notch to relieve pressure. Failure to follow this warning may cause death or injury
to personnel.
1.
Turn dipstick cap 1/4 turn to safety notch to relieve pressure. Drain hydraulic reservoir.
NOTE
Tag all hose and tube assemblies before disconnecting to aid in installation. Cap and plug
all ports. Remove caps, plugs, and tags following maintenance.
2.
Loosen four clamps (Figure 1, Item 7) and remove hose (Figure 1, Item 8) from suction tube
(Figure 1, Item 9).
3.
Remove four clamps (Figure 1, Item 7) from hose (Figure 1, Item 8).
4.
Remove four capscrews (Figure 1, Item 10), two cover plates (Figure 1, Item 11), and half clamps
(Figure 1, Item 12) from suction tube (Figure 1, Item 9).
5.
Loosen two T-bolt clamps (Figure 1, Item 13) and remove pump suction tube (Figure 1, Item 9) from vehicle.
6.
Loosen two T-bolt clamps (Figure 1, Item 5) and remove hoses (Figure 1, Items 6 and 14). Remove T-bolt
clamps (Figure 1, Item 5) from hoses.
7.
Remove four capscrews (Figure 1, Item 15), lockwashers (Figure 1, Item 16), and beaded insert
(Figure 1, Item 17) from vehicle. Discard lockwashers.
8.
Remove o-ring (Figure 1, Item 18) from inside beaded insert (Figure 1, Item 17). Discard o-ring.
9.
Remove four capscrews (Figure 1, Item 4), lockwashers (Figure 1, Item 3), and beaded insert
(Figure 1, Item 2) from vehicle. Discard lockwashers.
10.
Remove o-ring (Figure 1, Item 1) from inside beaded insert (Figure 1, Item 2). Discard o-ring.
0144-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00161)
