TM 5-3810-306-20
f
Install capacitor (10), diode silicon rectifier (9)
and wires to terminal block (11). Secure by
tightening screws.
g.
Install four wire pins in each relay plug (8)
according to diagram shown. Install relays (7).
h.
Install two wires 212 and 213 to resistor (6).
i.
Install wires and electrical connectors to relay
K5 (5).
j.
Install wires 112, 30 and 781 to circuit breakers
(4).
k.
Install wires 5A, 5B and 5C to buss bar on circuit
breakers (3).
l.
Install electrical connectors on flasher (2).
m.
Connect five electrical connectors on distribution
panel wiring harness (1).
2.
INSTALL DISTRIBUTION PANEL. (REFER TO
PAGE 8-30.)
3.
INSTALL FRONT SIDE ACCESS PANEL (REFER
TO PAGE 8-21.)
4.
CONNECT GROUND CABLE AT SHUNT.
(REFER TO PAGE 8-109.)
5.
CHECK FOR PROPER OPERATION OF ALL
ELECTRICAL COMPONENTS. (REFER TO TM 5-
3810-306-10.)
END OF TASK
8-28
