TM 5-3810-306-20
SIDE CONSOLE HARNESS INSTALLATION
TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
None
EQUIPMENT CONDITIONS: Disconnect ground cable at shunt. (Refer to page 8-109.)
Side console panel and access covers removed. (Refer to page 8-21.)
REMOVAL:
1.
REMOVE SIDE CONSOLE HARNESS (1).
a
Tag and disconnect electrical connectors to
panel light (2).
b.
Tag and disconnect electrical connectors to drive
axle toggle switch (3).
c.
Tag and disconnect electrical connectors to flood
lamp toggle switch (4).
d.
Tag and disconnect electrical connectors to rear
head lamp toggle switch (5).
e.
Tag and disconnect electrical connectors on wire
46 to outrigger control switches (6).
f.
Tag and remove two remaining electrical
connectors from each outrigger control switch
(6).
2.
REMOVE SIDE CONSOLE HARNESS (1).
INSTALLATION:
1.
INSTALL SIDE CONSOLE HARNESS (1).
a.
Connect
tagged
electrical
connectors
to
outrigger control switches (6).
b.
Connect two tagged electrical connectors to rear
head lamp toggle switch (5).
c.
Connect tagged electrical connectors to flood
lamp toggle switch (4).
d.
Connect tagged electrical connectors to drive
axle toggle switch (3).
e.
Connect tagged electrical connectors to panel
Light (2).
2.
INSTALL SIDE CONSOLE PANEL AND ACCESS
PANELS. (REFER TO PAGE 8-21.)
3.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
4.
TEST FOR PROPER OPERATION. (REFER TO
TM 5-3810-306-10.)
END OF TASK
8-24
