TM 5-3810-306-20
INSTALLATION:
1.
INSTALL ELBOW FITTINGS (4 AND 11) AND
SAMPLING VALVE (9) ON HEAD ASSEMBLY (3).
a. Put new preformed packings (8) on fittings (4
and 11). Install fittings (4 and 11).
b. Put new preformed packings (7) on sampling
valve (9). Install on elbow fitting (11).
2.
INSTALL HEAD ASSEMBLY (3) ON FRAME
MOUNTING STUDS.
a. Hold head assembly (3) in place on mounting
studs. Install four nuts (5), new lockwashers (6)
and flatwashers (10).
3.
CONNECT TWO TRANSMISSION OIL LINES (1
and 2).
a. Remove caps.
b. Connect flow "IN" oil line (1) to elbow (11).
c. Connect flow "OUT" oil line (2) to elbow (4).
4.
IF NECESSARY, FLUSH TRANSMISSION OIL
SYSTEM (REFER TO TM 5-3810-306-34.)
5.
SERVICE
TRANSMISSION/TORQUE
CONVERTER OIL (REFER TO LO 5-3810306-12).
6.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO
PAGE
8-109.)
END
OF
TASK
9-13
