TM 5-3810-306-20
Section IV. SEAT ASSEMBLY MAINTENANCE
OPERATOR SEAT AND PEDESTAL ASSEMBLY REMOVAL
TOOLS:
General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
Lockwashers (Item 43, Appendix C) (4 Required)
EQUIPMENT CONDITIONS: Cab bottom panel removed only to replace seat Belt.
(Refer to page 15-11.)
REMOVAL:
1.
REMOVE OPERATOR SEAT.
a. Remove nuts (11), lockwashers (12) and
capscrews (13) securing seat belt to seat suspension.
Discard lockwashers (12).
b. Loosen pedestal tightening knob (14).
CAUTION
Support seat before removing seat
height adjusting pin if seat is in an
elevated position.
c. Remove clip pin (15) and seat height adjusting
pin (16) from pedestal.
d. Lift seat out of pedestal and remove from cab.
2.
REMOVE PEDESTAL ASSEMBLY AND SEAT
BELT.
a. Remove
capscrew
(2),
flatwasher
(3),
lockwasher (4) and hex nut (5) securing seat belt
(1) to cab. Discard lockwasher (4).
b. Remove four capscrews (9), lockwashers (8),
flatwashers (7) and bushings (6) securing seat
pedestal (10) to cab floor. Discard lockwashers
(8).
15-27
