TM 5-3810-306-20
REASSEMBLY:
1.
REASSEMBLE
POSITIVE
SWING
LOCK
CONTROL LEVER.
a.
Install grommet (10) on control cable and mount
in cab wall.
b.
Push control cable (10) through cab wall.
c.
Assemble control lever (1) to control cable with
clevis pin (2), washer (17) and new cotter pin (3).
d.
Install control lever (1) with two capscrews (7),
spacers (9), clamp (18), washers (8), new
lockwashers (5), washers (4) and nuts (6).
Secure to cab mounting bracket.
e.
Secure cable (10) to mounting bracket with cable
clamp
(14),
two
capscrews
(13),
new
lockwashers (15) and nuts (16).
f.
Position control lever up (UNLOCK).
g.
Install clevis (11) and nuts (12) on control cable.
h.
Adjust clevis (11) and nuts (12) until clevis (11)
can be attached to swing lock block. Tighten
nuts (12).
i.
Secure control cable clevis (11) to swing lock
block with clevis pin (21), washer (20) and new
cotter pin (19).
2.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
3.
CHECK POSITIVE SWING LOCK FOR PROPER
OPERATION. (REFER TO TM 5-3810-30610.)
END OF TASK
17-16
