TM 5-3810-307-24-2-2
Rear Seal Housing - Removal (0-51)
8 mm
Remove the rear seal housing and gasket.
Support the seal area of the rear seal housing and
press/ drive out the seal.
Camshaft - Removal (0-52)
Measuring Gear Lash (0-53)
Position an indicator on a tooth to the camshaft gear.
NOTE
The cylinder block position shown in the
illustration is for clarity. The cylinder block
must be positioned with the crankshaft on top
to keep the tappets in the bores.
Note the camshaft gear backlash. Mark the camshaft
gear and crankshaft gear for further analysis if
backlash exceeds limits.
Camshaft Gear Backlash Limit (A)
mm
in
0.076
MIN
0.003
0.330
MAX
0.013
NOTE
Prevent movement of adjoining gear when
checking backlash or the reading will be the
total of both gears.