Table 3-3. Troubleshooting - Continued
Malfunction
Probable cause
Corrective action
7.
a.
Air cleaner clogged
a.
smoky
b.
Defective fuel injector
b.
8.
Engine clutch slips ---------------
a.
Clutch out of adjustment
a.
b.
Linkage out of adjustment ------------
b.
9.
Engine clutch will not engage
a.
Linkage out of adjustment ------------
a.
b.
Clutchout of adjustment
b.
c.
Worn clutch-------------------------------
c.
Report defect to general support
maintenance.
10. Engine temperature fails to
a.
Winterfront open at low ambient
a.
raise
temperature.
b.
Defective thermostat (stuck open)
b.
11. Water temperature indicator
a.
Loose electrical connection ----------
a.
Tighten all connections, Make
inoperative
good ground.
b.
b.
c.
Indicator defective ----------------------
12. Oil pressure indicator
a.
Loose electrical connections
a.
Tighten all connections. See that
inoperative
ground is good.
b.
b.
c.
Defective indicator -------------------
c.
13. Ammeter inoperative-------------- a.
Battery cables loose or corroded.
a.
Remove corrosion and tighten
b.
Dead batteries --------------------------
b.
c.
Ammeter defective --------------------
c.
14. Starter motor inoperative --------- a.
Loose electrical connections
a.
Remove corrosion and tighten
b.
Starter push switch defective
b.
c.
Batteries defective ---------------------
c.
d.
Defective starter motor ---------------
d.
15. Lights are dim or do not light
a.
Defective lamps or lights -------------
a.
thru 3-188).
b.
Short in wiring---------------------------
b.
c.
Batteries dead -------------------------
c.
d.
d.
Test and replace defective
regulator
16. Revolving frame teeters, or will.
a.
Hook rollers out of adjustment or
a.
not swing
worn excessively.
b.
Swing brake lock engaged,
b.
or out of adjustment.
c.
Swing jaw clutch out of ---------------
c.
adjustment.
17. Boom will not lower ---------------
a.
Boom hoist pawl still engaged ------
a.
b.
Brake does not release ---------------
b.
Adjust boom hoist lever and
18. Crane-shovel does not steer ---
a.
Steering gear not engaged ----------
a.
properly.
b.
Steering linkage, clutch, or brake
b.
out of adjustment
19. Cables twisted ---------------------
a.
Twisted during installation ----------
a.
Unwind cable from drum and rewind.
b.
Too much slack ------------------------
b.
Refer to applicable front end
attachment reeving diagram and
reeve correctly.
20. Cables wear rapidly --------------
a.
Sheave(s) dragging or defective
a.
Lubricate (LO 5-8810-201-12), or
replace defective sheave bearing
or shaft (refer to applicable
front end attachment paragraphs).
3-48