Front Wheel Bearing, Hub, and Drum

Section II. WHEELS, TIRES, AND SHOCK ABSORBERS

Rear Wheel Bearings, Drum, Hub, and Axle Shaft

TM-5-3810-207-20 Crane-Shovel Basic Unit Truck Mounted: 20 Ton 3/4 Cu.Yd. Gasoline Driven (Quickway Model M-200) Non-Winterized Manual
Page Navigation
171

TM 5-3810-207-20/TO 36C23-3-37-12 Figure 174. Front wheel, removal and installation. 284. Front Wheel Bearing, Hub, and Drum a. Removal. (1) Remove the front wheel (par. 283). (2) Remove the front wheel hub, drum, and bearings in the numerical sequence as instructed on figure 175. b. Cleaning and Inspection. (1) Clean all parts with an approved cleaning solvent. (2) Inspect the locknut, lockring, key washer, and bearing adjusting nut for damage. Replace as necessary. (3) Inspect the bearings and races for damage and excessive wear (TM 9- 214). Replace bearings as necessary. (4) Inspect all other parts for breaks, cracks, excessive wear, and other damage. Replace all parts and gaskets as necessary. c. Installation. (1) Pack the wheel bearings, using the prescribed lubricant (LO 5-3810-207- 20). (2) Install the wheel bearings, hub, and drum in the reverse of the numerical sequence as illustrated on figure 175. (3) Install front wheel (par. 283). NOTE When installing the bearing, tighten the bearing adjusting nut until the wheel locks; then back off on the adjusting nut until the wheel turns freely. 285. Rear Wheel a. Removal. Remove the rear wheels as instructed on figure 176. b. Cleaning and Inspection. (1) Clean the rear wheels with an approved cleaning solvent. 226

Privacy Statement
Press Release
Contact