TM 5-3810-207-20/TO 36C23-3-37-12
Figure 175. Front wheel bearings, hub, and drum, exploded view.
(2)
Inspect
the
rear
wheels
for
bent
condition and other damage. Replace
rear wheels as necessary.
c.
Installation. Install the rear wheels as
illustrated on figure 176.
286.
Rear Wheel Bearings, Drum, Hub, and Axle
Shaft
a.
Removal.
(1)
Remove the rear wheel (par. 285).
(2)
Remove the axle shaft, wheel bearings,
drum,
and
hub
in
the
numerical
sequence as instructed on figure 177.
b.
Cleaning and Inspection.
(1)
Clean all parts with an approved
cleaning solvent.
(2)
Inspect the wheel bearings and races for
excessive wear and other damage (TM
9-214).
(3)
Inspect all other parts for breaks,
excessive wear, and other damage.
Replace
all
defective
parts
as
necessary.
c.
Installation.
(1)
Pack the bearings using the prescribed
lubricant (LO 5-3810-207-20).
(2)
Install the wheel bearings, hub, drum,
and axle shaft in the reverse of the
numerical sequence as illustrated on
figure 177.
NOTE
When installing the bearings, tighten
the bearings adjusting nut until the
wheel locks; then back off on the
adjusting nut until the wheel turns
freely.
(3)
Install the rear wheel (par. 285).
287.
Tires and Tubes
a.
Removal.
(1)
Remove the wheel from the carrier (par.
283 and/or 285).
(2)
Deflate tire by removing valve core.
Insert pry bar in slot of retaining ring
near split. Pry end of ring out over edge
of rim, and remove ring from rim.
227
