Figure 178. Crane engine assembly, removal and
installation.
(12) Disconnect the transmission housing control
rods (para. 246).
(13) Remove the transmission assembly (para.
(14) Remove the carrier engine assembly as
instructed on figure 179.
b. Installation.
(1)
Install the carrier engine assembly as
illustrated on figure 179.
(2)
Install the transmission assembly (para.
Figure 179. Carrier engine assembly, removal and
installation.
(3)
Connect the transmission housing control
rods (para. 245).
(4)
Connect the air compressor lines (para.
(9)
Connect the throttle linkage (para. 89).
(10) Connect the clutch linkage (para. 245).
(5)
Install the exhaust pipe and muffler (para.
(11) Connect the fuel line (para. 85).
(6)
Install the air cleaner, duct, and shroud
(12) Connect the battery cables (para. 103).
(13) Install the engine hood (para. 258).
(7)
Connect the engine wiring.
(14) Fill the cooling system.
(8)
Install the hydraulic steering oil pump (para.
Section IV. CRANE ENGINE CARBURETOR ASSEMBLY
sealed, protecting all internal parts from dirt and moisture.
299. General
All air for fuel-air. mixture and engine operation is drawn
An updraft-type carburetor is used on the crane
through the air cleaner.
engine. This side-intake, single-venturi carburetor is
AGO 6819A
198
