Figure 3-38. (2) -Continued..
a Position the cooler element with a new gasket to
3-65. Cleaning, Inspection and Repair
the side of the cylinder block.
a Clean all parts with an approved cleaning solvent
b Hold it in place by installing the flatwashers,
and dry thoroughly.
lockwashers and capscrews in the two holes that go
b Inspect cooler housing and connectors for
through the element only.
cracks, breaks or worn condition. Repair or replace a
c Position the cooler cover with a new gasket to
damaged or defective part.
the element.
d Secure the cover with flatwashers, lockwashers
3-66. Reassembly and Installation
and capscrews. Torque the capscrews alternately to 30
Refer to figure 3-38 and proceed
as
follows:
35 ft-lbs.
Section XXII. CARRIER ENGINE OIL PRESSURE REGULATOR
3-67. Removal and Disassembly
a Remove pressure regulator as illustrated on
Carrier engine oil pressure regulator, removal and installation
Figure 3-39. Carrier engine pressure regulator
3-61
